Jeep Build Turns Ford 9-Inch and Humvee Parts Into Budget Rear Portal Axle

Zeph Gage’s rear-only portal axle uses a flipped differential, Humvee geared hubs, and custom Ford hardware to add clearance at a fraction of typical cost.

Portal axles are prized in hardcore off-roading because they raise a vehicle’s drivetrain components and add ground clearance, but a typical set can cost around $20,000. A build by Zeph Gage takes a different route: it uses a Ford 9-inch axle housing, Humvee geared hubs, and a set of Jesse Haines Fabrication HMMWV portal adapters to create a rear-only portal axle for a Jeep XJ at roughly one-fifth the usual cost.

Portal axles place a stack of gears behind each driven wheel rather than letting axle shafts and other hardware hang below the transmission and transfer case. That arrangement lets the axle shafts sit higher and leaves less hardware below the frame. With tall tires, it can create substantial clearance beneath the vehicle. The tradeoff is cost and complexity, especially when a vehicle was not originally designed for portals.

Gage’s setup addresses a basic direction problem. Two-gear portals such as the Humvee units reverse the rotation of the input shaft. To make the Ford 9-inch housing work with them, Gage flipped the differential upside down so the driveline would spin in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, turning low-pinion parts into what functions as a high-pinion arrangement.

The conversion adds about six inches of clearance. It also retains full shock travel, a detail that can be difficult to preserve with portal axles, and reduces stress on the differential itself. The build is described as reducing stress on the differential, with durability presented as an expected result rather than a tested guarantee.

Installing a portal only at the rear may seem unusual, but the approach is a common trick in the remote-control rock-crawler scene. Keeping the front solid axle avoids the packaging constraints that often arise when portal axles are added to a vehicle that never had them from the factory. It also avoids restricting shock travel to fit the front conversion and keeps the ride height from rising excessively. The arrangement is presented as a best-of-both-worlds compromise.

This is not an off-the-shelf kit. Gage performed extensive custom fabrication, including homemade brackets and custom-tapped plates. The brake package uses a two-piece rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric emergency-brake solenoid and because it helps with clearance.

The finished Jeep XJ can drive over a five-gallon bucket and still retain several inches of spare clearance. That means the rear end is less likely to hang up on obstacles that the front end can steer around. The build required considerable planning and fabrication to get right, but the effort was worthwhile.

AB

Astrid Berglund

Astrid writes as a vehicle cargo and roof system analyst covering roof racks, roof boxes, baskets, roof tents, and vehicle-mounted sports carriers. Her assessments work from documented roof load limits, crossbar spacing, mounting points, and rated carrier capacity, and separate static parked loads from dynamic driving cases rather than treating a box or basket label as a vehicle rating. She supports aftermarket buyers, outdoor equipment distributors, and installation teams who must confirm fitment, request test evidence, and manage packaging, returns, and lifecycle cost.